PROBLEMS | CHECK | ||
|
| The Caller ID unit will not function until you have sub- | |
The Caller ID display does not | scribed the Caller ID service from your local telephone | ||
company. Call your local telephone company to have | |||
show the caller’s information | |||
Call Waiting Caller ID service installed on your phone | |||
|
| ||
|
| line. Check your phone line connections. Also, fresh | |
|
| batteries MUST be installed. Make sure all your phone | |
|
| line connections are secure and corrected. | |
|
| If it is a private call or a blocked call, the caller’s name | |
|
| and/or phone number will not appear on the display. | |
|
| (You will see time & date of call plus some dashes or the | |
|
| words “ OUT OF AREA ”, “ UNAVAILABLE” or “ PRIVATE CALL”.) | |
|
|
| |
|
| Is any plug disconnected from the modular phone | |
No dial tone | plug? | ||
|
| Is any jack improperly wired? Use another phone to | |
|
| test the jack. | |
|
|
| |
Phone does not work | Are all cords connected properly ? Are all 4 “AA” | ||
batteries installed? Make sure they are installed ac- | |||
|
| ||
|
| cording to the polarity shown. | |
Phone does not ring | RINGER switch may be set to OFF? | ||
|
| Slide the switch to ON position. | |
|
|
| |
Cannot dial | Check the TONE/PULSE switch setting. | ||
You may only have PULSE service. Set the TONE/ | |||
|
| ||
|
| PULSE switch to PULSE position. | |
Display | showing erroneous | Reset the phone. Make sure the phone has hung up, | |
use a pointed object like a straightened paper clip and | |||
figures OR | |||
stick it into the small hole on the bottom of the phone | |||
No dial tone or low dial tone OR | |||
(marked RESET) for 2 seconds. After that reset the | |||
Can not dial out | |||
language and Area Code as shown in Page 7. | |||
|
| ||
Cannot | store numbers into | No batteries are installed or batteries are weak or | |
memory |
| installed | |
|
|
| |
Caller ID does not work | Make sure the Caller ID service is active. | ||
Check if the phone is connected to a working wall jack. | |||
|
| ||
|
| Check if all line cord connections are correct and secure. | |
The Caller ID display gets dim | Reset the contrast level of the LCD display. | ||
Or is blank | Check if batteries are properly installed. | ||
|
| Check if you have received the first Caller ID record. | |
|
| If you have received the first Caller ID record, your | |
|
| batteries may be weak. | |
Static noise on line or cannot hear | Make sure the handset cords connected properly. Or, | ||
calling party or calling party cannot | replace the COILED HANDSET CORD. Any phone store | ||
hear you |
| has these cords in different lengths. After some time the | |
|
| cord may have become overstretched or damaged. | |
|
|
| |
REDIAL does not work | Check if shows in the display. Since the REDIAL | ||
| |||
|
| button has combined function (pause function), the phone | |
|
| may have been paused. Just press the HOOK switch. | |
Feedback or squealing when | Volume is too high. Reduce the SPEAKERPHONE | ||
using SPEAKERPHONE | VOLUME control setting. | ||
NOTE: This phone will also work on regular (not Call Waiting) Caller ID service or if you don’t like Caller ID service, you may use this as a regular telephone.
15