Table 13: Device Configuration - Status
Hardware Revision |
MAC Address |
IP Address |
Product Model |
Part Number |
Software Version |
System Up Time |
Registered |
PPPoE Link Up |
Hardware version number: Main Board, Interface Board
The device ID, in HEXADECIMAL format.
This field shows IP address of GXP
This field contains the product model information.
This field contains the product part number
•Program: This is the main software (firmware) release number, always used to identify the software (firmware) system of the phone.
•Boot: Booting code version number
This field shows system up time since the last reboot.
Indicates whether accounts are registered to the related SIP server(s). GXP can support four unique SIP profiles.
Indicates whether the PPPoE connection is enabled (connected to a modem).
Table 14: Device Configuration – Basic Settings
|
|
|
|
| End User |
| This contains the password to access the Web Configuration Menu. This field is |
| Password |
| case sensitive with a maximum length of 25 characters. |
|
|
|
|
|
|
| There GXP operates in two modes: |
| IP Address |
| |
|
| ||
|
|
| 1. DHCP mode: all the field values for the Static IP mode are not used (even |
|
|
| though they are still saved in the Flash memory.) The GXP acquires its IP |
|
|
| address from the first DHCP server it discovers on its LAN. The DHCP |
|
|
| option is reserved for NAT router mode. To use the PPPoE feature, set the |
|
|
| PPPoE account settings. The GXP establishes a PPPoE session if any of |
|
|
| the PPPoE fields are set. |
|
|
| 2. Static IP mode: configure all of the following fields: IP address, Subnet |
|
|
| Mask, Default Router IP address, DNS Server 1 (primary), DNS Server 2 |
|
|
| (secondary). These fields are set to zero by default. |
|
|
|
|
|
|
| These options are used to assign a function to the corresponding multi purpose key. |
| Multi Purpose Key X |
| |
|
|
| Options available are: “Speed Dial”, “BLF”, “Presence Watcher” and “Eventlist BLF”. |
|
|
| Each function is connected to one of the accounts and has a target user ID. |
|
|
|
|
|
|
| This parameter controls the date/time display according to the specified time zone. |
| Time Zone |
| |
|
|
|
|
|
|
| Turn on LC backlight at all times. Default is No. This option applies to GXP- |
| LCD Backlight Always |
| |
| On |
| |
|
|
|
|
|
|
| LCD time display in 12 hour or 24 hour format |
| Time Display Format |
| |
|
|
|
|
Grandstream Networks, Inc. | GXP User Manual | Page 28 of 40 |
| Firmware 1.1.6.16 | Last Updated: 05/2008 |