Cortelco 9225 instruction manual BOX Contents, Battery Installation, Dialing Mode, Wall Mount

Page 9

INSTALLATION

BOX CONTENTS

Verify that the following items are in the box.

•Telephone

•Handset

•Handset Cord

•Line Cord

•3 AA Batteries

•Power Adapter

•Instruction Manual

BATTERY INSTALLATION

The 9225 telephone requires 3 AA size 1.5 V batteries for the LCD display. To install the batteries, follow the steps below:

1.Remove the battery cover. The cover is located underneath your phone.

2.Insert 3 AA size 1.5 V batteries. Be careful to observe the polarity markings in the battery compartment.

3.Replace the battery compartment cover.

DIALING MODE

The 9225 dial mode switch is underneath the phone near the battery compartment.

•If your telephone line supports touch-tone dialing, put the switch in the “T” position. This is the default postion from the factory.

•If your telephone line requires rotary (Pulse) dialing, put the switch in the “P” position.

•If you are unsure which system you have, set the switch to the TONE position. Lift the handset. When you get a dial tone, dial a telephone number. If the dial tone

continues, move the switch to PULSE, and then dial the telephone number again. Note: When in PULSE mode, holding the * key for approximately 3 seconds will switch

to Tone dialing for the duration of the call.

WALL MOUNT

1.The 9225 ships configured for wall mounting. No changes are necessry.

2.Connect the power adapter. The power adapter connects to the jack marked DC 9V on the back of the phone. Plug the large part of the adapter into the wall outlet. Use only a 9V DC. 300mA, center positive Class 2 adapter. The adapter is necessary for LCD backlighting.

3.Connect the line cords. Lines 1 and 2 may be connected to one jack and brought into the telephone with one 4 conductor modular cord. If you have this type of connection, plug the line cord into the Line 1/2 jack (Item 4 on Page 8) Also Line 1 and Line 2 may connect to 2 separate jacks and connect to the telephone with two line cords. In this case, plug Line 1 into the Line 1/2 Jack (Item 4 on Page 8) and Line 2 into the Line 2/Data jack (Item 1 on Page 8) .

4.Mount the phone on the wall jack.

5.Plug the coiled cord into the handset, and then plug the other end of the cord into the handset jack.

6.Place the handset on the base

.

9

 

Page 8 Page 10
Image 9
Page 8 Page 10
Contents OWNER’S Caller ID Type Table Of Contents Speed Dial Important Safety Instructions Page Telephone Part Identification Back and Side BOX Contents InstallationBattery Installation Dialing ModeDesk Mount Ringer VolumeAnswering Machine Modems and FAX MachinesEnter Unit SetupMenu Basic Operation Feature Buttons Hold Button Line 1 Button / Line 2 ButtonConf Button Redial Button Volume ButtonCall Forward on Call Forward OFFSpeed Dial Phone Book Review the Contents of a Memory ButtonStore a Caller ID Record to a Memory Button Adding AN Entry to the Phone BookDialing from the Phone Book Caller IDDeleting a Phone Book Entry Storing a Caller ID Record in the Phone BookCaller ID on Call Waiting Private CallsReviewing Calls Deleting CallsTroubleshooting Clude the Original Sales Receipt Telephone RepairFCC Information Limited Warranty
Top Page Image Contents