Oricom UHF050 manual Factory Reset, To program a receive channel

Page 18

Operation

To program a receive channel.

1.Press and hold the 60Rx button for 2 seconds, the display will show channel 41. to select a different channel use the Channel control.

2.Press the PRI button, the 450 in the frequency display will start blinking, use the Channel control to select the desired MHz.

3.Press the PRI button, the 000 in the frequency display will start blinking, use the Channel control to select the desired KHz.

4.Press MEM, the frequency is stored to that channel.

Factory Reset

Should it be necessary you can return all the UHF050 settings to the factory defaults to do this.

1.Switch the unit OFF.

2.Press and hold the CALL button.

3.While still holding the Call button, turn the power switch to ON, this will reset the factory defaults.

18

Image 18
Contents User Guide Page Table of contents Please read before installing or operating your Oricom Radio Safety Warning Blasting Caps and AreasControls and Connectors Front ViewRear View MicrophoneBox Contents Antenna InstallationDC Power DIN KitOptional External Speaker Squelch Power on / OFFDual Function buttons To Select a ChannelTo Turn on BCL Transmitting Busy Channel Lock BCLTo Transmit To Turn OFF BCLCall Tone Ctcss Continuous Tone Coded Squelch SystemDCS Digitally Coded Squelch Receive & Transmit Indicator Time Out Timer ToTDuplex Operation To Turn Duplex DPX on To Turn Duplex DPX OFFRoger Beep RGB Emergency Channel EMGPriority Channel PRI Beep Tone BPT Memory ScanPriority Scan LCD Display ControlsRx channels Factory Reset To program a receive channelSpecifications Frequency Table Channel Channel Frequency MHz Usage 476.425 Duplex RX/SimplexChannel Frequency MHz Usage 476.925 Simplex Warranty Customer Support