Chapter 3: Getting the Voice Mail System Up and Running
STEP 5
Connect Sprint
Digital Voice to Your
Phone System
Figure 4:
To connect Sprint® Digital Voice to a Protegé® system:
1.Plug one end of a modular line cord into Voice Mail Port 1 on Sprint Digital Voice. See Figure 4.
2.Connect the other end into the RJ11 modular jack that is connected to an analog port on the phone system (Note: on the 3x8 and CTX systems, this will be an Analog Adapter. On the MTX and LTX, the analog port may be from an analog station card or Analog Adapter.)
3.Repeat steps 1 and 2 for voice mail ports 2, 3 and 4 (if ports 3 and 4 are installed).
4.Verify that all cabling and connections are correct. Plug in the AC adapter connector to the voice mail, and then plug the AC adapter into an electrical outlet.
Note: If using a phone system other than Protégé, refer to the Release Notes for Software Versions and the Integration Guide for further options.
IMPORTANT NOTE
Extensions will receive notification of new messages (flashing Intercom LEDs) only when voice mail port 2 is connected to the phone system. This is the factory default and can be modified if required.
For further information refer to STEP 8 of this guide.
Connecting Sprint Digital Voice to the Protegé Phone System
Issue 1.6 | Getting the Voice Mail System Up and Running – ◆ – 11 |