Oricom TP170WP manual To review the Phone Book Memory, To dial a number from the Phone Book

Page 14

7.2 To review the Phone Book Memory

1.Press and release CID button until the phone symbol is shown.

2.Review the stored phone number by pressing or , or enter the first letter of the name of the person you wish to call. After a short time, the display will display the first stored telephone number and say the name if it was recorded.You can now search for further numbers under this letter by pressing .

Notes:

•If no telephone numbers are stored, the display will show EMPTY.

•After you view all the call in memory, the display will show END OF LIST.

7.3 To dial a number from the Phone Book:

1.With the required telephone number showing on the display, press CALL BACK button. The telephone dials out the displayed telephone number automatically in speakerphone mode.

2.The display shows the telephone number and call timer.

OR

1.Pick up the handset or press SPEAKER button (the speaker light will turn on) and wait for a dial tone.

2.Press and release CID button, symbol is shown.

3.Review the stored phone number by pressing or .

4.Press CALL BACK button.

7.4 Recording / Editing / Deleting voice prompt of name of phone book

With caller ID service activated, when an incoming call is received, the unit will display and announce the caller's phone number (unless it is blocked). If the caller's phone number is stored in the phone book, caller's name will be displayed too.

If the voice prompt is recorded for this phone number, the unit will announce the voice prompt instead of the caller's phone number.

1.Press and release the MENU button until the NAME RECORDING is shown.

2.Press the OK button. A list of the phone book entries will be displayed.

3.Press or to select the list you like to record a voice or name for it.

4.To record or edit the voice, hold down OK button. After the beep, speak clearly into the microphone. Release the button when you are finished (max recording time is 3 seconds.) The new voice prompt will then be replayed automatically.

To delete the voice prompt recorded, press DELETE button while the voice prompt is playing.

5.Repeat steps 3 to 4 to edit or delete entries or exit the set-up mode by pressing the CID button.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Page General Information REN RN for New Zealand Caller IDLocation of controls N13134Connecting the mains power supply InstallationInstalling batteries supplied in the phone Connecting the telephoneWall Mounting Setting the Time and Date Setting UpSetting the contrast Voice PromptsRinger Volume Control Receiver Volume ControlReceiver Tone Volume Control Hearing Aid CompatibilityTelephone Operation Pairing new pendants to the phoneRemote Pendant setting Making a callLast number Redial Speaker Volume ControlReceiving a Call Pre Dialing a CallPause Network Message Waiting IndicatorCall waiting Recall button Storing numbers in the M1 & M2 one touch memoriesPhone Book Storing numbers in the phone bookOverview To review the Phone Book Memory To dial a number from the Phone BookTo Edit Phone Book Memories To Delete the Phone Book MemoryTo record your emergency message Emergency Call featureEmergency Message To check your emergency messageTo activate the Emergency Call function View the Caller ID Memory Caller IDReceiving a Call Can be stored up to 64 calls Copy from the Caller ID to the Phone Book Deleting Numbers from the Caller ID MemoryCall Back Redial from the Caller ID Memory Important Information 10.1Periodic testing10.2Battery Backup on the phone base 10.5Warranty Information Consumer Support and TroubleshootingCleaning and care WarrantyAustralia Page 2LMC70YY
Top Page Image Contents