Basic Steps to Install
1.Connect the plug of the mains adapter to the adaptor socket on the back of the base unit and the mains adapter to the wall mains supply.
2.Connect the telephone lead to the phone cord socket on the back of the base unit and to the wall phone socket.
3.Fit the 2 AAA batteries, observing the polarity, into the battery compartment on the handset.
4.Slide the battery door firmly into place.
5.Place the handset on the base unit and let the batteries charge for a full 14 hours before using for the first time.
Caution
Use only the mains adapter supplied with this telephone. Incorrect adapter polarity or voltage can seriously damage the unit.
Adapter Model No: VD090030C
Input: 230 VAC 50 Hz
Output: 9 VDC 300 mA
Caution
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. Use only the original type supplied with this telephone. The high performance
Charging the Handset
When the empty battery icon 
is displayed, the batteries need recharging. When you are talking on the phone, you’ll also hear a series of short beeps as warning.
Place the handset on the base cradle to recharge the handset batteries. The charge light on the phone base will be on.
7 of 16
BASIC OPERATION
During Standby
HS
When the phone is in standby, the LCD displays the handset label. The battery icon reflects the current battery charge level and the signal icon indicates the handset is linked to the base.
Answering an Incoming Call
12345678901234
When there is an incoming call, the phone rings and the 
icon flashes.
If a caller’s number (CID) record is received, the 
icon turns on and the number, if any, is displayed.
•Icon turns on if the phone number contains more than 14 digits. In this case, only the last 14 digits are displayed.
1.Press 
to answer the call, the 
icon turns on.
2.The call timer will show on the display 10 seconds after the call is connected
3.Press 
again or place the handset on the base cradle to disconnect.
Making a Call
Your phone allows you to dial out a phone number in various ways.
Normal dialling
1.Press 
and wait for the dial tone. The 
icon turns on.
2.Use the number pad to dial the phone number. The display shows the digits as you enter them.
3.When you enter more than 14 digits, the 
icon turns on. In this case, you only see the last 14 digits on the screen.
Pre-dialling
1.Enter the phone number. The display shows the digits as you enter them. 
will be displayed for ¾ and 
for # .
2.To enter a pause, press and hold 
. A pause is displayed as “P”.
8 of 16