Recharging the Battery Pack

The nickel metal hydride (Ni-MH) BATTERY PACK in the HANDSET can be recharged many times using the built-in charger in the BASE UNIT.

When the BATT LOW LED indicator starts to blink rapidly, a “beep”sound will be heard every 12 seconds. This indicates that the BATTERY PACK needs to be recharged.

Charge the BATTERY PACK at least once every 90 days of non-use to avoid battery failure. When the BATTERY PACK can no longer be charged, replacement of the BATTERY PACK will be necessary.

NOTES:

1.During a power interruption, the BASE UNIT does not operate, and a phone conversation cannot be made on the HANDSET.

2.To ensure your phone charges properly, place the HANDSET on the BASE UNIT and make sure that the CHARGE LED indicator on the BASE UNIT lights up and a “beep” confirmation tone is heard.

Changing the BATTERY PACK

The BATTERY PACK provides power for the HANDSET of your cordless telephone.

To Replace the BATTERY PACK:

1.Remove the HANDSET BATTERY COMPARTMENT COVER by sliding it down.

2.Pull out the BATTERY PACK PLUG and remove the BATTERY PACK.

3.Plug the new BATTERY PACK into the BATTERY CONNECTOR.

4.Slide the HANDSET BATTERY COMPARTMENT COVER firmly into place in its closed position.

5.Before use, charge the new BATTERY PACK for 12 hours.

ATTENTION:

The telephone that you have purchased contains a rechargeable BATTERY PACK. The BATTERY PACK is recyclable. At the end of its useful life, under various state and local laws, it may be illegal to dispose of this BATTERY PACK into the municipal waste stream. Check with your local solid waste officials for details in your area for recycling options or proper disposal.