Sunbeam STC580 owner manual FCC Requirements, FCC Notice

Page 18

FCC Requirements

FCC NOTICE

The FCC requires that you be advised of certain requirements involving the use of this telephone.

1.This telephone is hearing aid compatible.

2.This equipment complies with Part 68 of the FCC Rules. A label on the BASE UNIT of this equipment contains, among other information, the ACTA Product Number and the Ringer Equivalence Number (REN) for this equipment. You must, upon request, provide this information to your telephone company.

3.The REN is also useful in determining the quantity of devices that you may connect to your telephone line and still allow these devices to ring when your telephone number is called. In most areas, but not all, the sum of the RENs for all devices connected to one line should not exceed five (5.0). To be certain of the number of devices that you may connect to your line, you should contact your local telephone company.

4.If your telephone causes harm to the telephone network, the telephone company may temporarily disconnect your service. If possible, they will notify you in advance that temporary discontinuance of service may be required. However, when advanced written notice is not possible, the telephone company may temporarily discontinue service without notice if such action is necessary under the circumstances.

5.The telephone company may make changes in its communication facilities, equipment, operations, or procedures that could affect the proper operation of your equipment. If they do, you will be provided with advance notice as to give you an opportunity to maintain uninterrupted service.

6.This equipment may not be used on coin service provided by the telephone company. Connection to party lines is subject to state tariffs. (Contact your state public Utility Commission or Corporation Commission for information.

7.An FCC compliant telephone cord and modular plug is provided with this equipment. This equipment is designed to be connected to the telephone network or premises wiring using a compatible modular jack which is Part 68 compliant. See Installation Instructions for details.

8.Please follow instructions for repairing if repairing any (e.g. battery replacement section), otherwise do not alter or repair any parts or device except specified.

9.The USOC number of the registration jack for this equipment is RJ11C.

17

Image 18
Contents Model STC580 Contents Safety Instructions Important Safety InstructionsBattery Safety Handset Controls Microphone Antenna Base Unit Controls Base Unit ControlsConnecting Your Phone Getting StartedBelt Clip Installation Cordless Telephone Operation Preparing for UsePlacing Calls Receiving Calls with the Handset on the Base Unit Receiving Calls with the Handset off the Base UnitStoring Numbers Redial Feature Mixed Mode Temporary Tone DialingRecalling Stored Numbers from Memory Using the Headset Feature Mute FunctionSecurity System Resetting Security Code and Channel InformationMulti-Channel Access Security SystemChanging the Battery Pack Recharging the Battery PackRecharging the Battery Pack To Replace the Battery PackProblem Solving Phone does not work, check the followingNoise Technical InformationTechnical Information RangeFCC Requirements FCC NoticeRinger Equivalence Number FCC Requirements