Radio Shack ET-007 owner manual Mounting the Corded Phone on a Wall or Wall Plate

Page 8

43-007.fm Page 8 Wednesday, March 22, 2000 11:24 AM

The INTERCOM and HOLD indi- cators on the corded phone stop flashing after the headset charger and wireless headset are con- nected, even when there is no battery pack in the headset. If they flash, move the headset and charger closer to the corded phone.

Remove the battery insulation strip from the infrared remote dial card’s battery compartment. Then place the dial card in its cradle on the headset charger.

If you cannot operate the headset using the remote dial card, you might need to replace the dial card’s battery. Slide off the battery compartment cover and use a pointed object (such as a straightened paper clip) to gently pry out the old bat- tery. Insert a fresh CR2025 lithium but- ton-cell battery (available from your local RadioShack store), then replace the cover.

Note: To detach the supplied carry strap, gently pull on the carry strap’s small loop, then pull the strap through the small loop. To reattach the strap, slide the small loop into the carry strap slot on the remote dial card. Then insert the strap through the small loop and pull to tighten.

8

MOUNTING THE CORDED PHONE ON A WALL OR WALL PLATE

You can use the supplied mounting bracket to mount the corded base phone on a wall.

Notes:

When mounting the base telephone on a wall plate, use the supplied modular cord to connect the phone to the wall plate jack.

To mount the base telephone directly on a wall, use two 3/16-inch

(5mm) screws (not supplied). Drill two holes 315/16 inches (100 mm) apart. Then thread a screw into

each hole, letting the heads extend about 1/8 inch (3 mm) from the wall.

1.To connect the bracket, insert the tabs on the bracket into the slots in the lower position on the base. Then press the upper side of the bracket to the base until it snaps into place.

To remove the bracket, press in the upper tab on each side of the bracket and lift the bracket away from the base.

2.Plug one end of the supplied modu- lar cord into the phone’s TEL.LINE jack and the AC adapter's barrel plug into the DC jack.

Image 8
Contents ET-007 Features Read this Before Installation FCC StatementFm Page 4 Wednesday, March 22, 2000 1124 AM Contents Selecting a Location InstallationConnecting Handset Wireless Headset Charger Mounting the Corded Phone on a Wall or Wall Plate 315/16 Inches Charging the Battery Pack PreparationSetting the Dialing Changing the Ringer Mode Tone Setting the Ringer Volume Adjusting HeadsetListening Safely Making and Answering Calls Switching Between the Handset and the HeadsetOperation Setting the Handset and Headset Volume Using the IntercomUsing Redial Using FlashUsing Hold Using Tone Service on a Pulse LineMemory Dialing Storing a Number In MemoryEntering a Pause in a Memory Number Dialing a Memory NumberUsing the Intercom Testing Stored Emergency NumbersChain-Dialing From the BaseTroubleshooting Fm Page 21 Wednesday, March 22, 2000 1124 AM FCC Wants YOU to Know CareLightning Fm Page 23 Wednesday, March 22, 2000 1124 AM RadioShack Division of Tandy Corporation Fort Worth, Texas