Radio Shack 43-3578 Recharging the Battery Pack, Before you try to charge it. The CHARGE/IN USE

Page 13

To charge the battery pack, place the handset on the base. The CHARGE/IN USE indicator on the base lights and Total:00 appears on the handset display.

Recharge the battery pack when Low Battery flashes on the display.

If you have trouble replacing the battery pack, take the phone to your local RadioShack for assistance. o !

Recharging the Battery Pack

•When you first use the phone after charging or recharging the battery pack, the phone might not work and you might hear an error tone when you press TALK/FLASH.

While holding PAGE, return the handset to the base for about 3 seconds to reset the security access-protection code.

•If the base loses power for about an hour while the handset is away from it, the security access- protection code might be lost. To reset the code, while holding PAGE, return the handset to the base for about 3 seconds.

oWARNING o Dispose of the old battery pack promptly and properly. Do not burn or bury it. There is a risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions.

! IMPORTANT !

Be sure the battery pack is properly connected

before you try to charge it. The CHARGE/IN USE

indicator lights when the handset is on the base, even if the battery pack is not connected.

Installation

13

Image 13

Contents With Caller ID/Call Waiting 900MHz Cordless TelephoneContents Introduction FCC Statement Important InformationImportant Information Surge Protection Important Safety Instructions Caller ID Information Selecting a Location InstallationOn a Wall Plate or Wall On a Desk TopSupplied AC EPA certified Rbrc Battery Recycling Seal on CONNECTING/CHARGING the Battery PackBefore you try to charge it. The CHARGE/IN USE Recharging the Battery PackInstallation Setting the Ringer Tone and Volume Turning Caller ID/CALL Waiting ON/OFF Turning Auto TalkPress VOL/ twice to move the cursor to Area Code Storing Your Area CodeSetting the Dialing Mode Selecting the Language Making and Receiving Calls OperationUsing Redial Adjusting HANDSET’S VolumeSelecting the Channel Using Tone Services on a Pulse Line Using FlashMuting the Ringer Paging Voice Mail Waiting IndicatorUsing a Headset Installing the BeltclipTo attach the beltclip To remove the beltclipStoring a Number and Name in Memory Memory DialingMemory Dialing Memory XX Stored appears Editing or Deleting a Number in Memory Entering a PauseReviewing Memory Numbers Dialing a Memory Number CHAIN-DIALING Service NumbersSpeed Dialing Testing Stored Emergency NumbersStoring a Number in Speed Dial Editing the Speed Dial Number Dialing the Speed Dial NumberDeleting the Speed Dial Number Caller ID Operation Reviewing Caller ID Records Data Caller ID MessagesDialing Numbers from a Caller ID Record ADDING/DELETING the Area CodeStoring a Caller ID Record in Memory Deleting All Caller ID Records Deleting a Single Caller ID RecordDeleting Caller ID Records Troubleshooting Keep the handset away Move the base away from Care Service and RepairPage RadioShack Corporation