To enter a special character, press 0. Each time you press 0, the following characters appear in this order:
∗# – & ( ) (space) 0
If you make a mistake, use
∗/TONE/ or #/ to move the cursor over the error, then enter the correct character, or press CH/ DEL to delete a character. To delete all characters, hold down CH/DEL for at least 1 second.
6.Press SEL. Store Number appears.
7.Enter the number and any tone and pause entries (see “Using Tone Services on a Pulse Line” on Page 22 and “Entering a Pause” on Page 28). Ô
8.Press SEL. The phone beeps and
Memory XX Stored appears (XX
= number). After a few seconds, a list of memory location number appears, and you can repeat Steps
Ô NOTE Ô
Each tone or pause entry uses one digit of memory.
Memory Dialing
27