Radio Shack TAD-1018 Setting the PHONE’S Volume, Using Tone Services with a Pulse Line

Page 13

Note: If you do not have any special telephone services, pressing FLASH might disconnect your current call.

SETTING THE PHONE’S VOLUME

Slide VOL (volume) on the handset to set the handset’s volume to the de- sired level.

USING TONE SERVICES WITH A PULSE LINE

Some special services, such as alter- nate long-distance and bank-by- phone, require tone signals. If you have pulse service, you can still use special services by following these steps.

1.With TONE/PULSE set to PULSE, call the special service.

2.When the service answers, press TONE. Any additional numbers you dial are sent as tone signals.

3.When you complete the call, hang up the phone. The phone auto- matically changes back to the pulse mode.

13

Image 13

Contents TAD-1018 Answering System FeaturesTelephone FCC Statement Read this FirstContents Selecting a Location InstallationLoading Cassette Recording the Outgoing Message Connecting PowerChecking the Outgoing Message Mounting the Phone on the Wall Placing the Phone on a Desk TOPPage Setting the Number of Rings Setting the Dialing ModeTurning OFF/ON the Ringer Page Using Redial Using PauseUsing Flash Telephone OperationUsing Tone Services with a Pulse Line Setting the PHONE’S VolumeSetting Recording Time Setting the Answering System to Answer CallsSetting the Answering SYSTEM’S Volume Answering System OperationPlaying Messages Screening CallsPage Remote Playback Remote Control OperationErasing Messages Remote ANSWER-ON Problem Cause Solution TroubleshootingProblem Cause Solution Care and Maintenance Lightning FCC Wants YOU to KnowPage RadioShack Division of Tandy Corporation Fort Worth, Texas