Radio Shack TAD-1018 owner manual Placing the Phone on a Desk TOP, Mounting the Phone on the Wall

Page 8

PLACING THE PHONE ON A DESK TOP

To use your answering system on a desk, table, or shelf, plug the tele- phone cord into a modular phone jack.

Plug one end of the coiled handset cord into the handset jack on the an- swering system and the other end into the jack on the handset. Place the handset on the cradle.

1.Pull the handset holder toward you as far as it will go. Hold it out as you rotate the holder 180°, then let it snap back in place.

The holder’s tab holds the hand- set in the cradle while the answer- ing system is mounted on the wall.

2.To mount the TAD-1018 directly onto the wall, drill two holes 31/4 inches apart, one above the other, at the desired location.

MOUNTING THE PHONE ON THE WALL

Using the supplied mounting bracket, you can mount the TAD-1018 on a phone jack wall plate or directly on the wall.

If you are mounting the phone directly on the wall, you need two screws with heads that fit into the bracket’s key- hole slots.

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents TAD-1018 Telephone FeaturesAnswering System Read this First FCC StatementContents Loading Cassette InstallationSelecting a Location Connecting Power Recording the Outgoing MessageChecking the Outgoing Message Placing the Phone on a Desk TOP Mounting the Phone on the WallPage Turning OFF/ON the Ringer Setting the Dialing ModeSetting the Number of Rings Page Using Pause Using RedialUsing Flash Telephone OperationSetting the PHONE’S Volume Using Tone Services with a Pulse LineSetting the Answering System to Answer Calls Setting Recording TimeSetting the Answering SYSTEM’S Volume Answering System OperationScreening Calls Playing MessagesPage Erasing Messages Remote Control OperationRemote Playback Remote ANSWER-ON Troubleshooting Problem Cause SolutionProblem Cause Solution Care and Maintenance FCC Wants YOU to Know LightningPage RadioShack Division of Tandy Corporation Fort Worth, Texas
Top Page Image Contents