Telephone Operation, Making Receiving Calls

43-775.fm Page 16 Friday, August 13, 1999 3:25 PM

TELEPHONE OPERATION

Note: You can use the keypad on ei- ther the handset or the base to oper- ate the TAD-1016. To use the features during a call, however, you must use the same keypad that you used to make or answer that call.

Using the Speakerphone

To make or answer a call using the speakerphone, press SPEAKER. The SPEAKER indicator on the base lights.

MAKING AND

RECEIVING CALLS

Using the Handset

To make or answer a call, lift the hand- set. Or, if the handset is off the base, press TALK. The BATT LOW indicator on the handset and the IN USE indica- tor on the base light.

To end a call, place the handset on the base or press TALK on the handset.

Notes:

•If you press TALK to hang up and the phone does not disconnect, press TALK again while holding the handset closer to the base or place the handset on the base.

•You cannot use the handset if someone is using the TAD at the base. If you press TALK when the TAD is being used, the handset beeps 3 times.

To end a speakerphone call, press SPEAKER again. The indicator turns off.

Note: You cannot use the speaker- phone if someone is using the TAD from the handset. If you press SPEAK- ER when the handset is being used, the SPEAKER indicator flashes.

Switching Between the Handset and Speakerphone

To switch from the handset to the speakerphone at any time during a call, press INTERCOM on the handset then INTERCOM on the base, and then hang up the handset (place the hand- set on the base or press TALK on the handset).