Radio Shack TAD-1016 owner manual Selecting AN Outgoing Message, Recording an Outgoing Message

Page 24

43-775.fm Page 24 Friday, August 13, 1999 3:25 PM

5.Press for AM or for PM. The TAD beeps, then announces the time you set through the handset, and beeps again.

Notes:

The seconds start to count from 00 when you set AM or PM.

If you make an error, the handset beeps 5 times. Repeat the steps to enter the day and time cor- rectly.

SELECTING AN OUTGOING MESSAGE

The TAD has two pre-recorded mes- sages. One asks the caller to leave a message (“Hello, no one is available to take your call. Please leave your message after the tone.”); the other is simply an announcement and does not let the caller leave a message (“Hello, no one is available to take your call.”). You can also record your own message (see “Recording an Outgoing Message”).

Use the REC TIME switch to select which message you want. When you set it to either 1 or 4 (minutes), the nor- mal message is selected and the TAD records each incoming message for up to 1 or 4 minutes. When you set it to ANN, the announce-only message is selected.

24

Recording an Outgoing Message

You can record your own message up to 1 minute long for the caller to hear when the TAD answers a call. Use the handset to record the message.

If you record an outgoing message, the TAD plays it instead of either pre- recorded message. Depending on the REC TIME switch setting, either tell callers to leave a message or state your message as an announcement only.

Hint: Do not tell callers that you are not home; instead, say that you can- not come to the phone right now.

Follow these steps to record your out- going message.

1.Press REMOTE on the handset so the BATT LOW indicator lights green.

2.Hold down OGM REC/8 for about 2 seconds until the TAD beeps. Then speak your outgoing mes- sage into the handset.

Image 24
Contents TAD-1016 Read this Before Installation FCC StatementFeatures TAD FeaturesFm Page 4 Friday, August 13, 1999 325 PM Contents Using the Toll-Saver Accessing the TAD by Remote Installation Selecting a LocationPlacing the Base on a Desktop Mounting the Base on a Wall Plate Upper Grooves Lower Mounting the Base Directly on the Wall Fm Page 11 Friday, August 13, 1999 325 PM Removing the Protective Sheet Connecting and Charging the Battery Pack Telephone PreparationSetting the Dialing Mode Turning OFF/ON BASE’S Ringer Using the Speakerphone Using the HandsetSwitching Between the Handset and Speakerphone Telephone OperationChanging Channel Putting a Call on HoldUsing the Intercom Using RedialUsing Flash Memory Dialing Storing a Number in MemoryEntering a Pause Testing Stored Emergency Numbers Chain-Dialing Service NumbersDialing a Stored Number Setting the Number of Rings TAD OperationSetting the DAY and Time Setting the Remote Operation PINSelecting AN Outgoing Message Recording an Outgoing MessageSetting the TAD to Answer Calls Screening Calls Recording a MemoPlaying Messages Fm Page 27 Friday, August 13, 1999 325 PM Adjusting the TAD’S Volume Deleting MessagesUsing the TOLL-SAVER Accessing the TAD by RemoteRemote Operation Fm Page 30 Friday, August 13, 1999 325 PM Troubleshooting Problem SuggestionFm Page 32 Friday, August 13, 1999 325 PM Care and Maintenance Replacing Battery Pack FCC Wants YOU to Know LightningRadioShack