Installation
Ô NOTES Ô
•If you place the handset on the base to recharge it while the headset is connected, be sure the handset seats properly.
•You can use a handset holder (available from your local RadioShack store) to hang the handset on your belt for greater convenience when using a headset.
INSTALLING A BELTCLIP
To attach the beltclip
Insert the beltclip into the holes on each side of the handset. Press down until it clicks.
To remove the beltclip
Pull either side of the beltclip to release the tabs from the holes.
USING A HEADSET
You can make or answer calls with hands- free convenience using an optional headset that has a
RadioShack has a variety of headsets available.
To connect the headset, gently flip open the rubber headset jack cover on the side of the handset, then insert the headset’s plug into the jack. Ô
Connecting a headset disconnects the handset’s earpiece and microphone.
VOL/RING/
or VOL/RING/
on the handset also controls the headset’s volume.
With a headset connected, you can make or answer calls as usual using the keys on the handset.
When you finish using the headset, disconnect it from the handset and close the rubber cover to protect the jack.
12