Radio Shack 43-5560 owner manual Steps for Entering Names and Special Characters

Phonebook

Ô NOTES Ô

Storing Phone Numbers,

Names, Distinctive Rings,

and Speed Dial

•The pause key counts as one digit. Pressing the PAUSE soft key, more than once increases the length of the pause between numbers. Each pause represents a two second delay.

•If you choose not to store a “Distinctive Ring”, simply select the “No Selectn” option.

•Selecting a speed dial location where a number is already stored, releases the old number’s speed dial setting. The new number will be stored in the speed dial location.

•If you choose not to store the name/number as a Speed Dial, simply select the “No Selectn” option.

Steps for Entering Names and Special Characters

•If the next character uses the same number key, you must press #/> to move the cursor over. Otherwise the next time you press the number key, it changes the character that was previously set.

5.Press the number keypad to enter the phone number (up to 20 digits), press the OK soft key to store the number. Ô

6.Distinctive Ring appears. Press

VOL/RING/ or VOL/RING/ to move the pointer to one of the Distinctive Ring options, and then press the OK soft key. Ô

7.Speed Dial appears. Press

VOL/RING/ or VOL/RING/ to move the pointer to select the Speed dial location (ten locations: SPD1-SPD0).

Ô

8.Press the OK soft key. You will hear a confirmation tone, and Done! appears in the display.

STEPS FOR ENTERING NAMES AND SPECIAL CHARACTERS

Refer to the letters on the number keys to select the desired characters. With each press of a number key (0-9), the displayed character appears in the following order:

upper case letters first, lower case letters next and finally the number corresponding to the key.Ô

Number of times key is pressed

32