3.Route the other end of the short cord through the hole in the bracket’s center.
4.Attach the supplied bracket to the bottom of the base by inserting the tabs on the bracket into the slots on the base, then sliding the bracket up.
5.Insert the supplied AC adapter’s barrel plug into the 12VDC jack on the back of the base. Then plug the adapter into a standard AC outlet.
7.Align the bracket’s keyhole slots with the wall plate studs and slide the base downward to secure it.
8.Carefully place the handset in the cradle at the top of the base and make sure it is secure.
Note: If you later want to mount the base on a desktop, press PUSH on the bracket and pull it off to remove it.
9.Fully extend the base’s antenna and place it in a vertical position.
6.Plug the modular cord into the wall plate’s jack.
Mounting the Base Directly on the Wall
You need two wood screws (not sup- plied) for this mounting method.
1.Drill two holes 315/16 inches apart. Then thread a screw into each hole, letting the heads extend 1/4 inch from the wall.
7