Radio Shack ET-542 owner manual Preparation, Connecting Battery

Page 7

43-1042.fm Page 7 Tuesday, August 17, 1999 10:28 AM

PREPARATION

CONNECTING THE

BATTERY

Important: You must connect the bat- tery inside the handset before charg- ing the phone and using it. Follow these steps to connect the battery.

1.Use a screwdriver to remove the screw on the battery compartment cover on the back of the handset, then press down on the cover and slide it off.

2.Plug the battery wire connector into the socket inside the compart- ment.

3.Align the screw hole on the bat- tery compartment cover with the screw hole inside the battery com- partment.

4.Tighten the screw about halfway. Then press down and slide the cover up to lock it in place.

5.Fully tighten the screw to ensure the best water seal.

Before you use your phone for the first time, charge it for 15 hours.

Note: The connector fits only one way. Do not force it.

7

Image 7
Contents ET-542 Features Fm Page 3 Tuesday, August 17, 1999 1028 AM FCC Statement Read this Before InstallationContents Installing the Base InstallationSelecting a Location Preparation Connecting BatteryCharging Battery Turning ON/OFF the Ringer Setting the Dialing ModeMAKING/ANSWERING a Call OperationUsing Redial Using FlashChanging Channels Memory Dialing UsingStoring a Number in Memory Entering a Pause A Memory Number Problem The handset does not work Solutions TroubleshootingProblem Can receive calls, but cannot make calls Care and Maintenance Replacing Battery Lightning FCC Wants YOU to KnowRadioShack Division of Tandy Corporation Fort Worth, Texas