Radio Shack ET-542 owner manual Replacing Battery

Page 18

43-1042.fm Page 18 Tuesday, August 17, 1999 10:28 AM

REPLACING THE

BATTERY

If you follow the instructions in “Charg- ing the Battery,” the supplied battery should last about a year. When the battery loses its ability to fully charge, order a 3.6-volt, 300-mAH battery with a connector that fits the socket in the battery compartment. You can order a replacement battery through your lo- cal RadioShack store.

Install the new battery as described below, then charge the battery (see “Charging the Battery”).

1.Use a screwdriver to remove the screw on the battery compartment cover on the back of the handset, then press down on the cover and slide it off.

Note: The connector fits only one way. Do not force it.

4.Align the screw hole on the bat- tery compartment cover with the screw hole inside the battery com- partment.

5.Tighten the screw about halfway. Then press down and slide the cover up to lock it in place.

2.Gently pull on the battery connec- tor to disconnect it, then remove the battery.

3.Plug the battery wire connector into the socket inside the compart- ment, and place the battery inside the compartment.

18

6.Fully tighten the screw to ensure the best water seal.

Image 18
Contents ET-542 Features Fm Page 3 Tuesday, August 17, 1999 1028 AM Read this Before Installation FCC StatementContents Installation Installing the BaseSelecting a Location Connecting Battery PreparationCharging Battery Setting the Dialing Mode Turning ON/OFF the RingerOperation MAKING/ANSWERING a CallUsing Flash Using RedialChanging Channels Using Memory DialingStoring a Number in Memory Entering a Pause A Memory Number Troubleshooting Problem The handset does not work SolutionsProblem Can receive calls, but cannot make calls Care and Maintenance Replacing Battery FCC Wants YOU to Know LightningRadioShack Division of Tandy Corporation Fort Worth, Texas