Radio Shack owner manual Installation, Mounting the TRC-488

Page 4

21-1585.fm Page 4 Thursday, August 5, 1999 9:39 AM

INSTALLATION

MOUNTING THE TRC-488

If you use the TRC-488 as a base sta- tion, you can mount it on a desk, shelf, or table.

The most common mounting location for the CB is under a vehicle’s dash- board. If you use the TRC-488 in a ve- hicle, mount it securely to avoid damage to the CB or vehicle or injury to anyone in the vehicle during sudden starts or stops.

When you mount the CB in a vehicle, make sure:

You can easily reach the CB.

Its wires and cables do not inter- fere with any of the vehicle’s mov- ing parts.

The CB is not directly in front of heating vents.

All wires and cables reach their connection points.

Follow these steps to mount the CB using the supplied bracket, screws, washers, and knobs.

1.Using the mounting bracket as a template, mark the positions for the screw holes.

(illus)

2.In each marked location, drill a hole slightly smaller than the sup- plied screws.

Caution: Be careful not to drill into any objects behind the mounting surface.

3.Using a Phillips screwdriver, attach the mounting bracket to the mounting location with the sup- plied screws and lock washers.

(illus)

4

Image 4
Contents TRC-488 Channel 2-WAY CB RadioFeatures Contents Installation Mounting the TRC-488Mounting Microphone Holder Connecting AN Optional External Speaker Connecting MicrophoneConnections Connecting Power Using Vehicle Battery PowerInstalling AN Antenna Adjusting ANTENNA’S SWR Setting Squelch Using Automatic Noise LimitingOperation Listening to Weather BroadcastsReceiving Transmissions on the Channels Transmitting Common Uses for a CB Radio CB TipsCB Courtesy Using Common 10-CODES Code MeaningTroubleshooting Problem SolutionMaximum Range Reducing NoiseMaintenance Replacing the Fuses FCC InformationSpecifications ReceiverRadio Shack Limited Warranty