1.To record the OGM 1 (or OGM 2) message for each line, hold down OGM 1 (or OGM 2) until the TAD beeps and both ANSWER indicators flash.
Notes:
•Proceed next step within 8 seconds. Otherwise, the TAD sounds a short beep, and you must start again from Step 1.
•Recording OGM 2 only does not turn on the TAD. You must start re- cording OGM from OGM 1.
2.Press ANSWER above the desired LINE 1 or LINE 2, and speak your message from about 8 inches from the front of the TAD.
3.When you finish, press STOP. The TAD beeps and plays back the out- going message.
Note: When you finish recording OGM 1 only, the TAD automatically sets to answer on. The ANSWER in- dicator above LINE 1 lights.
cators flash. Then press ANSWER within 8 seconds on the selected line and the message plays after the beep.
If there is no announcement recorded, you hear “You have no announcement one (or “two”) in line one (or “two”)” when you press its button.
SETTING THE NUMBER OF RINGS
Set each line’s ring select switch to 2, 4, 7, or TS to set how long the TAD waits before it answers a call (2 rings, 4 rings, 7 rings or
If you plan to check your messages by long distance, set the ring select switch to TS (see “Using the
Checking the Outgoing
Messages
To check an outgoing message, press its button (OGM 1 or OGM 2). You see the announcement number A1 or A2, the TAD beeps and both ANSWER indi-
11