USING CALL
BREAKTHROUGH
If you screen your calls but want to know when calls come in from certain people, give them your call breakthrough (CBT) code.
When a caller enters the CBT code dur- ing the outgoing message, the TAD alerts you with a series of loud beeps for 35 seconds. To answer the call, pick up the handset. If you do not answer, the caller can leave a message after the outgoing message plays.
Changing the CBT Code
The CBT code is preset to 648, but you can change it by following these steps.
Note: Be sure to complete each step within 8 seconds. Otherwise, the TAD beeps four times and you must start over from Step 1.
1.Hold down CODE until the TAD beeps. Co (code) appears.
2.Press REPEAT. Cc (CBT code) ap- pears, and the TAD announces and shows the current code’s numbers in sequence. Then the first digit of the code reappears.
3.Repeatedly press SKIP or REPEAT to set the first digit, then press STOP. The second digit appears.
16
4.Repeatedly press SKIP or REPEAT to set the second and third digits, pressing STOP after each digit. The TAD beeps and announces the new CBT code.
CHANGING THE REMOTE OPERATION SECURITY CODE
The remote operation security code is preset to 739, but you can change it by following these steps. Do not use the same number you choose for the CBT code.
Note: Be sure to complete each step within 8 seconds. Otherwise, the TAD beeps four times and you must start over from Step 1.
1.Hold down CODE until the TAD beeps. Co (code) appears.
2.Press CODE again. Sc (security code) appears, and the TAD an- nounces and displays the current code’s numbers (739) in sequence. Then the first digit of the code ap- pears.
3.Repeatedly press SKIP or REPEAT to set the first digit, then press STOP. The second digit appears.
4.Repeatedly press SKIP or REPEAT to set the second and third digits, pressing STOP after each digit. The TAD beeps and announces the new remote operation security code.