REMOTE OPERATION
While you are away from your home or office, you can use a
•set the TAD to answer calls
•listen to your messages
•record a new announcement
•record a memo
•delete messages
•monitor the room where the TAD is located
Note: You cannot remotely operate the TAD from another phone on the same line as your
USING REMOTE
COMMANDS
Follow these steps to operate the TAD remotely.
1.Dial either one of your phone num- ber which you connected with the TAD.
2.When the TAD answers, enter your remote operation security code. The TAD beeps once to confirm that you entered the correct code.
Notes:
•If you do not enter each digit of the security code within 8 sec- onds, the TAD hangs up.
•Even if the TAD is not set to an- swer calls, it will answer after about 9 rings.
USING THE TOLL-SAVER
If the ring select switch is set to TS (toll- saver) (see “Setting the Number of Rings” on Page 11), the TAD answers after two rings if you have new messag- es. If there are no new messages, the TAD waits for four rings before it an- swers. This gives you time to hang up before the TAD answers so you can avoid unnecessary
3.Enter a remote command (see “Re- mote Commands” on Page 18).
4.When you finish, simply hang up.
17