ClearSounds 40XLC user manual Phone Mounting Installations, Desk / Table Use, Wall Mount Use

Page 15

PHONE MOUNTING INSTALLATIONS

The telephone may be placed on a shelf or table, or may be fixed to a wall using the mounting bracket.

Plug the AC Adapter into the AC power back on the back of your phone, then into an electrical outlet or surge protector, if you are using one. NOTE: The adapter is required for the telephone to work correctly. If the adapter is accidentally unplugged (or in case of power failure) and if the batteries are dead or not installed, minimal restricted phone features only will work on the phone (make a call or answer incoming call).

IMPORTANT: Please remove the clear plastic Caller ID tab. This film tab is only for display and to protect your Caller ID display during shipping.

Desk / Table Use

1.Connect one end of the 6ft telephone cord to the line jack on the back of your 40XLC Phone and connect the other end to a modular phone jack (RJ11C).

2.Connect the handset coil cord (curly cord) to the handset and to the telephone

(See figure #17).

3.Lift the handset and listen for a dial tone. If you hear a dial tone, your phone is ready to use. If there is no dial tone, check all your cords to make sure they are plugged in securely.

Figure #17 – Desk Installation

Wall Mount Use

1.Slide the handset hanger tab out and reverse its position (rotate it 180 degrees). Slide it back into place so that the hook points up (See figure #18). This will keep the handset from falling out of the cradle when it is mounted on the wall.

2.Plug the 8in short phone cord into the telephone jack on the 40XLC, run phone cord underneath wall plate adapter and through the opening.

3.Insert the Wall Plate adapter. Hold the wall plate adapter so that the raised mounting pins line up with the phone’s keyholes on the 40XLC. Once the holes are lined up, push the wall plate adapter in towards the 40XLC and then slide the plate upwards until it is securely seated on the phone. (See figure #19)

4.With the Wall Plate adapter installed, plug the 8in short phone cord into the jack on the wall.

5.Holding the phone slightly above the mounting screws on the wall jack, push the phone against the mounting screws so they are hooked into upper and lower key-

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents 40XLC Congratulations on your purchase Table Of Contents Specifications 40XLC Miscellaneous Feature SettingTroubleshooting Guide Warranty and ServiceComponents Please Save These Instructions Flash button Redial button Features & FunctionsFigure #3 Figure #4 Figure #5 Care of PhoneInstallation Steps Installing the Optional BatteriesSetting the Dialing Mode Ring Style Strobe & Optional Bed Shaker Ring SignalingRinger Volume Programming the Ringer & Auxiliary AlertProgramming Memory Dial Buttons Figure #10 Strobe Ringer Flashing incoming call indicatorFigure #13 Phone Mounting Installations Desk / Table UseWall Mount Use Figure #18 Reversing The Hook Using the Speakerphone 40XLC Phone OperationMaking and Receiving a Call Using Audio and Telephone Headset Accessory Jacks Using the Amplification Function Receiving/Answering a CallVoice Amplification and Tone Figure #24 Amplify Button Using the volume reset override Using your 40XLC Amplified Phone with hearing aidsUsing the Outgoing Speech Volume 40XLC Caller ID Operation Using The Last Number RedialUsing The Flash Button Using The Mute ButtonViewing Incoming Calls Battery Low IndicatorReview Call History Turn OFF the New Calls / Message Waiting Indicator LightRemove All Call Records Remove Call Record From The Caller ID ListCall Waiting Remove a Specific Call Record40XLC Miscellaneous Feature Settings Set The Language Turn on The Call Waiting Caller ID FeatureDisplay Screen Messages Set Area Code / LDS Long Distance Service Code Hour format LCD / Screen Contrast AdjustmentChoosing The Date / Hour Format Date formatSetting Up Your Phone Book DIMTo Add a New Number/Name To Review / Modify a Number/Name In Your Phone Book To Delete a Number From Your Phone BookTo Save Numbers From Caller ID To The Phone Book Recall / Delete One Of the Last 30 Numbers Dialed Auto on HookTo Dial a Number From The Phone Book No dial tone Troubleshooting GuideMaximum Outgoing Gain DimensionsSpecifications Maximum GainFCC Registration Notice Power RequirementsThis equipment is hearing aid compatible
Top Page Image Contents