Aastra Telecom AT-200HT owner manual Setting the Time and Date

Page 11

1.Press the review ! or q buttons as required to set the first digit of your area code. Press the ERASE button to move to the second digit.

2.Press the review ! or q buttons as required to set the sec- ond digit of your area code. Press the ERASE button to move to the third digit.

3.Press the review ! or q buttons as required to set the third digit of your area code. Press the ERASE button to move to set the correct time and date.

Setting the Time and Date

The AT-200HT has a built-in real time clock that will keep the current time and date. The clock is automatically set during the first call and is updated each time Caller-ID information is re- ceived.

1.It is not necessary to enter the correct time and date when the display indicates "SET TIME/DATE" after setting your area code.

2.Press the ERASE button as required until the display enters the Stand-By Screen mode as shown below.

3.After completing the setup procedure, you can change any of the above settings.

9

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Headset Telephone With 70 Name and Number Caller ID Table of Contents Important Safety Instructions Page Battery Cautionary Instructions Page Page Battery Installation InstallationSetting the Display Language Setting the Area Code Setting the Time and Date Using the Headset Installing the Belt ClipPage ConnectingLOWto the telephone line Telephone Jack Tel. Line Jack Headset Jack Operation Setting the Tone/Pulse switchSetting the Ringer Off/Low/Hi switch Making Calls Receiving Calls Using the Redial button Using the Mute Button Using the Flash buttonUsing the Pulse to Tone dialing feature Reviewing Call Records Using the Call TimerUsing the Pause feature Private Calls Line Error Erasing All Calls Erasing Individual CallsLow Battery Indication Care and Maintenance No Dial Tone Troubleshooting
Top Page Image Contents