![](/images/new-backgrounds/1139428/1394287x1.webp)
for 2 seconds.
5.This is the end of the auto detection stage. If the OESWC TRANSMITTER detected the vehicles radio successfully the led will light up solid red.
6.Make sure the steering wheel control buttons function correctly in the vehicle and enjoy your radio.
So what if the led does not light up solid red? Check out troubleshooting section below.
Troubleshooting the Auto Detect Mode
So you tried the auto detect feature and at the end the led did not stay on solid red, it started flashing. That means the OESWC TRANSMITTER did not detect the vehicles radio. Follow these couple steps to determine what happened:
First some basic steps:
1.Verify that you have 12 volt accessory and a good ground to the
OESWC interface.
2.Verify that the battery is good on the OESWC transmitter.
3.Refer to the “Setting up the OESWC transmitter” section of this manual and repeat those steps.
3