GE 15381860 manual To SET the LCD Contrast, To SET the Dial Mode, To Exit Setup

Page 10

TO SET THE LCD CONTRAST

This adjustment allows optimization of the contrast and viewing angle of the display.

1.Press and release the REVIEW up button then hold down the REVIEW down button.

“SETUP MENU ^ v” appears.

2.Press the REVIEW up button until “LCD CONTRAST” appears.

3.Press the DELETE button to show the current contrast setting. There are 5 levels of contrast, with the default set to 3.

4.To decrease the contrast, press REVIEW down. To increase, press REVIEW up.

5.Press DIAL to store the contrast setting and return to the “LCD CONTRAST” display.

TO SET THE DIAL MODE

This adjustment allows you to select tone (touch-tone) or pulse (rotary) mode dialing.

1.Press and release the REVIEW up button then hold down the REVIEW down button.

“SETUP MENU ^ v” appears.

2.Press the REVIEW up button until “T/P DIAL MODE” appears.

3.Press the DELETE button to show the current dial mode. The default is set to tone.

4.To change the dial mode, press REVIEW up or down. The display will alternate between the two modes.

5.Press DIAL to store the dial mode and return to the “T/P DIAL MODE” display.

TO EXIT SETUP

To exit the setup mode after your changes have been made, you can immediately exit by selecting the “EXIT SETUP” menu and pressing the DIAL button.

NOTE: The phone will exit setup after 10 seconds if no buttons are pressed.

REMINDER: The time and date are programmed automatically when the first Caller ID information is successfully received after setup.

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents 9190 FCC Registration Information Notification to the Local Telephone CompanyInterference Information Do not OpenTable of Contents Introduction Before YOU Begin Parts ChecklistModular Jack Requirements Important Installation Information Installation & SetupInstalling the Batteries Setting UP the Caller ID Menu Exit SetupTo SET Your Local Area Code To SET the CID Display LanguageTo Exit Setup To SET the Dial ModeTo SET the LCD Contrast Installing the Phone To Install on a DesktopTo Mount on a Wall Receiving and Storing Calls Caller ID FeaturesSummary Screen Unlocking the Caller ID ButtonDeleting Call Records If YOU Programmed Your Local Area Code in the Setup MenuReviewing Call Records Dialing BackDigits Message Indicators Unknown CallTelephone Basics Changing the VolumeUsing ONE Touch Redial Redialing a NumberTo Store Frequently Called Numbers Using Memory FeaturesTo Store EMERGENCY/QUICK Dial Numbers To Change a Stored NumberTo USE Flash To Erase a Stored NumberTo USE Pause Redial To USE Temporary Tone DialingTroubleshooting Tips Incoming and Outgoingvoice Volume LOW ServiceTone Feedback Flutter When Dialing in Pulse Mode Index Page Limited Warranty What we will do
Top Page Image Contents