GE 15381860 manual Troubleshooting Tips

Page 20

TROUBLESHOOTING TIPS

NO DIAL TONE

•Check all cabling to make sure that all connections are secure and not damaged.

•Check hook switch: Does it fully extend when handset is lifted from cradle?

NO DISPLAY

•Replace batteries.

•Check for proper battery installation.

NO INFORMATION IS SHOWN

AFTER THE PHONE RINGS

•Did you order Caller ID service from your local telephone company? This unit requires that you subscribe to Caller ID service in order to work.

•Be sure to wait until the second ring before answering.

ERROR MESSAGE IS DISPLAYED

•ERROR appears in the display if the unit detects anything other than valid Caller ID information during the silent period after the first ring. This message indicates either the presence of noise on the line, or that an invalid message has been sent from the telephone company.

PHONE DOES NOT DIAL OUT

•Check the dial mode in the setup menu. Is it set to tone, which may not be compatible with your local dialing service?

PHONE DOES NOT RING

•Is the ringer switch in the OFF position?

•Are you using too many phones on one line? (The total REN of all phones on the same line should not be greater than the maximum REN for your calling area. See FCC Registration Information)

•Perform the checks under the first problem (Number 1). Is the hook switch depressed fully when handset is in cradle?

20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents 9190 FCC Registration Information Notification to the Local Telephone CompanyInterference Information Do not OpenTable of Contents Introduction Modular Jack Requirements Parts ChecklistBefore YOU Begin Installing the Batteries Installation & SetupImportant Installation Information Setting UP the Caller ID Menu Exit SetupTo SET Your Local Area Code To SET the CID Display LanguageTo SET the LCD Contrast To SET the Dial ModeTo Exit Setup Installing the Phone To Install on a DesktopTo Mount on a Wall Caller ID Features Summary ScreenReceiving and Storing Calls Unlocking the Caller ID ButtonIf YOU Programmed Your Local Area Code in the Setup Menu Reviewing Call RecordsDeleting Call Records Dialing BackDigits Message Indicators Unknown CallChanging the Volume Using ONE Touch RedialTelephone Basics Redialing a NumberUsing Memory Features To Store EMERGENCY/QUICK Dial NumbersTo Store Frequently Called Numbers To Change a Stored NumberTo Erase a Stored Number To USE Pause RedialTo USE Flash To USE Temporary Tone DialingTroubleshooting Tips Tone Feedback Flutter When Dialing in Pulse Mode ServiceIncoming and Outgoingvoice Volume LOW Index Page Limited Warranty What we will do
Top Page Image Contents