FLASH AND CALL WAITING
USING THE PHONEBOOK
TIP
You must subscribe through your local telephone company to receive Call Waiting Service.
If you have Call
Waiting service and
a call waiting tone sounds while you are on a call, press TALK/FLASH to accept the waiting call. There is a short
pause, then you will
hear the new caller. To return to the original caller, press TALK/FLASH again.
Phonebook allows you to dial a number using just a few key presses. It stores names/numbers in the Phonebook memory location, and you can search names in alphabetical order. You have a total of 100 locations that can be used for the Phonebook (including the Speed dials) and Caller ID messages.
If any of the following occurs while using the Phonebook function, operation will be canceled.
PHONEBOOK
MESSAGE LED
The message waiting LED on the
remote is designed to work with your
voice mail service provided by your
local telephone company. The LED flashes when you have new incoming messages in the voice mail service.
You may need to occasionally reset the indicator if it remains On after you’ve retrieved your messages. To reset the indicator, when the phone is in the standby mode press and hold PAGE on the base until the paging sound stops (about 5 seconds).
14
•Press END. The phone will return to the standby mode (or the call will be disconnected).
•Press TALK/FLASH.
•Place the remote in the base.
•Press DELETE, or receive an incoming call or PAGE (from the standby mode only).
•Receive a CIDCW (Caller ID on Call Waiting) (during a call only).
TIP
If the remote remains idle for 30 seconds, the phone will return to the standby mode (or back to the call).
15