Siemens Gigaset M49AM user manual Remote Access, How to deal with common failures Phone

Gigaset M49AM user manual

Remote Access

This phone has remote access function. You can access it via other double-tone phones: Put through to the answering machine,

After the Owner Message, enter remote access code,

The menu will be audibly played as:

	The audio instructions for remote control
	Press 2	Play the incoming messages
	Press 2 again	Stop
	Press 0	Erase the current message
	Press 1	Backward
	Press 3	Forward
	Press 4	Activate or deactivate
	Press 7	Play the functional table
How to deal with common failures
Phone
Question			Solution
No tone or pulse dialing signal		z Check if you have fit the phone cord into
			the “Line” socket at the back of the base
			and fit the other end into the phone line
			socket on the wall.
		z	Be sure the power line of the base is
			connected to the power socket.
		z Unplug the phone cord of the base, then
			insert the phone cord into another phone to
			make sure if the same problem happens. If
			so, it’s the problem of the phone cord or
			phone service.
		z Be sure the batteries are fully charged (16
			hours).
		z Check if the batteries are inserted correctly.
		z The handset might be located too far away
			from its range. Move it closer to the base.
		z Press the Talk key on the handset to check
			if there is dial tone and the indicator “In
			Use” on the base lights. If not, the batteries
			need charging.
		z	Place the handset back to the base for
			another 20 seconds.
Can not make calls though with dialing signal		z Be sure to set correctly the tone or pulse
			dialing.
No rings on handset/base		z Be sure to set the ring ON.
		z The handset might be located too far away
			from its range. Move it closer to the base.
		z	Check if you have installed too many
			extensions. If so, unplug some.
Noise, or call interrupted		z The handset might be located too far away
			from its range. Move it closer to the base.
		z Relocate the base to avoid sharing power
			sockets with other appliances.
		z Place the handset back to its base to charge.
Dialing from stored caller-ID		z Did you enter the correct location code of
			the stored number?
		z	Did you follow correct steps to dial the

25