Emerson EM6120-2 manual Rings to answer, To change the rings to answer setting

Page 21

Rings to answer

The answering system is factory preset to answer an incoming call after 6 rings, this however may be adjusted by following the instructions below:

rings to answer

rings to answer

To change the “rings to answer” setting:

1. Press and HOLD the rings to button until the system emits a

answer

tone and the following voice prompt, “please set rings”.

2.

Use the

buttons to change the number of rings up or down

3.

If you select “TS” (toll saver) the answering system will

 

answer after 5 rings if there are no new messages, and

 

after 2 rings if there are new messages.

4. When you are finished, press the

rings to

button to confirm

 

answer

 

the setting.

If voicemail is included as an option from your telephone company, it is important to set the answering system to answer before the voicemail system of the phone company, otherwise your messages will be recorded in the voicemail system of the phone company and not the answering system’s voice mailbox

rings to answer

To check the “rings to answer” setting:

• Press the

rings to

button to check how many rings before the

 

answer

 

answering system will respond to an incoming call

“6 rings”

rings to

security

answer

code

delete

Press to check or press and HOLD to adjust

Page 20 Page 22
Image 21
Page 20 Page 22
Contents User Guide Box Installing the bracket Installing the batteryGetting started Wall MountingRechargeable battery warning Important installation informationTelephone jack requirements Handset ConnectingStandby Screen Handset / Using the phoneVolume SpeakerRedial Phonebook Dialing a number from the phonebookAdding numbers to the phonebook Answer calls End callsCall Waiting / Flash Reviewing Caller ID information Caller ID / Call Waiting Caller IDIntercom Using multiple handsetsCopy a phonebook entry to another handset Adding a new handset Additional handsetsMenu Paging BaseAnswering system Power on/offOutgoing message Recording an outgoing messagePlayback messages Playback messagesTo skip messages Message is played backTo delete a single message Deleting messagesMessage erased To change the rings to answer setting To check the rings to answer settingRings to answer Remote access To remotely access your answering systemTo turn on the answering system from a remote location To check the security code To change the security codeImportant safety instructions FCC Part 68 information Compliance informationHearing Aid Compatibility To Obtain Warranty Service Limited WarrantyWarranty service not provided
Top Page Image Contents