Curtis TC984 Recharging the Battery Pack, Changing the Battery Pack, To Replace the Battery Pack

Page 30

Recharging the Battery Pack

Recharging the Battery Pack

The nickel metal hydride (Ni-MH) Battery Pack in the Handset can be recharged many times using the built-in charger in the Base Unit.

When the BATT LOW symbol appears on the LCD Screen, a “beep” sound will be heard every 12 seconds. This indicates that the Battery Pack needs to be recharged.

Charge the Battery Pack at least once every 90 days of nonuse to avoid battery failure. When the Battery Pack can no longer be charged, replacement of the Battery Pack will be necessary.

NOTES:

1.During a power interruption, the Base Unit does not operate, and a phone conversation cannot be made on the Handset.

2.To ensure your phone charges properly, place the Handset on the Base Unit with Telephone Keypad face up, and make sure that the CHARGE LED indicator on the Base Unit lights up and a “beep” confirmation tone is heard.

Changing the Battery Pack

The Battery Pack provides power for the Handset of your cordless telephone.

To Replace the Battery Pack:

1.Remove the Handset Battery Compartment Cover by sliding it down.

2.Pull out the Battery Pack PLUG and remove the Battery Pack.

3.Plug the new Battery Pack into the Battery Connector.

4.Slide the Handset Battery Compartment Cover firmly into place in its closed position.

5.Before use, charge the new Battery Pack for 12 hours.

ATTENTION:

The telephone that you have purchased contains a rechargeable Battery Pack. The Battery Pack is recyclable. At the end of its useful life, under various state and local laws, it may be illegal to dispose of this Battery Pack into the municipal waste stream. Check with your local solid waste officials for details in your area for recycling options or proper disposal.

29

Image 30
Contents Page Contents Contents Safety Instructions Important Safety InstructionsBattery Safety Handset Controls Microphone Base Unit Controls Connecting Your Phone Getting StartedBelt Clip Installation Cordless Telephone Operation Preparing for UseReceiving Calls Redial Feature Placing CallsUsing the Headset Feature Caller ID System Operation Caller ID SystemCaller ID with Call Waiting MSG Waiting Message WaitingOne-Touch Voice Mail Dialing Caller List Viewing the Caller ListPlacing a Call from the Caller List Deleting a Single Record Storing Caller ID Records into the Directory Phone bookDeleting Caller ID Records Deleting All RecordsViewing the Directory Phone book Storing Phone NumbersTelephone Keypad Characters ExamplePlacing Calls from the Directory Phone book Editing a Stored Number in the Directory Phone bookDeleting a Stored Number in the Directory Phone book Preferred CallsBlocked Calls Function Settings Keypad FunctionSetting the Ringer Level Changing the LanguageSetting the Time and Date Adjusting the ContrastTurning the First Ring on or OFF Setting the PBX Number Changing the Flash TimeChanging the Pause Time Programming One-Touch Voice Mail DialingDeleting Message Waiting Indication Setting the Area Code Registering the HandsetMulti-Handset Stystem Operation Transfer CallSecurity System Resetting Security Code and Channel InformationMulti-Channel Access Security SystemChanging the Battery Pack Recharging the Battery PackRecharging the Battery Pack To Replace the Battery PackProblem Solving Problem Solving Noise Technical InformationTechnical Information RangeFCC Requirements FCC NoticeRinger Equivalence Number FCC Requirements