Doro 15R, 10, 20, 25R manual Out of memory, Answer machine settings, Remote activation

Page 11

English

Out of memory

The memory has room for up to 59 messages (including the outgoing message) max. 15 minutes (the NeoBio 15r) or 30 minutes (the NeoBio 25r) depending on the compression you set. When TAM FULL is shown or the base unit flashes FF, no new messages can be recorded until the old ones have been played back and deleted. In that case, the telephone answer machine responds with the outgoing message for Answer Only.

PLEASE NOTE!

Remember to delete messages regularly!

Answer machine settings

1. Press . Scroll to ANS. MACHINE. Press OK.

2.Scroll to TAM SETTINGS. Press OK.

3.Scroll to desired function. Press OK.

4.Scroll to desired setting. Press OK.

ANSWER MODE Choose between ANSWER & REC and ANSWER ONLY (caller cannot leave message). TAM Language Select language for pre-recorded outgoing message. To activate this, press C (right menu

button) during playback of outgoing message.

Ogm settings Record/listen to outgoing msg.

ANSWER Delay Select after how many rings (2,4,6,8, time saver*) the call will be answered. Record time Select maximum recording time for each msg.

Remote acc. Select remote access off/on.

COMPRession Higher compression gives longer recording time but reduced sound quality, LOW = best sound quality but about half memory capacity.

BS SCREENING Enable/disable the function in base unit which is described in chapter Screening.

CHANGE PIN Change remote access code (0000).

The Time Saver function answers calls after six ring signals, until the first new message has been registered

-then the answer machine switches to answering after approximately two signals. This is useful when using remote access; if you call up the answer machine and there is no reply after four rings that means there are no messages recorded and you can hang up before you are charged for the call.

Remote activation

The answer machine can be activated via the remote access functions.

1.Call the answer machine. It will answer after approximately 10 rings.

2.Press * when the outgoing message is played.

3.Enter the PIN code, see Answer machine Settings. One beep confirms correct code.

4.Press 7.

5.Replace the handset.



Image 11
Contents NeoBio 10/15r/20/25r NeoBio 15r/25r Français EnglishPlease note BatteryConnection Range Battery LEDBase unit indicators Volume controlIncoming numbers/Caller ID Temporary silent modeSoftkeys Phonebook Functions System settingsRegister a new handset Expanded system Two or more handsets e.g +1Screening Switching the answer machine on/offAnswer machine only NeoBio 15r/25r Outgoing messagePersonal message Memo Use of answer machine base unitUse of answer machine handset Remote activation Answer machine settingsOut of memory Troubleshooting Remote accessDeclaration of conformity GuaranteeSpecific Absorption Rate SAR Australia NEW Zealand Australia and New ZealandRemarque RaccordementBatteries Témoin de chargeTouche Bis Réglage du volumeAppeler Recevoir un appelNeoBio 15r/25r uniquement Présentation du numéroRecherche du combiné Témoins de la baseDéclaration d’un nouveau combiné Configuration du systèmeSystème élargi Packs Utilisation du répondeur base Mise en/hors service du répondeurRépondeur NeoBio 15r/25r uniquement AnnonceMémoire pleine Utilisation du répondeur combinéMémo message personnel FiltrageAccès à distance Configuration du répondeurEn cas de problèmes Activation à distanceDéclaration de conformité DAS Débit d’Absorption Spécifique Garantie et S.A.VEnglish French Version