Cobra Electronics CP-9135 Replacing Handset Batteries, Handset Battery Disposal

Page 22

CP9135 manual layout.6 10/20/98 12:41 PM Page 44

Operation

Operation

Replacing

Handset

Batteries

Note

Replacement batteries are available direct from Cobra. See Accessories section on page 48.

Replacing Handset Batteries

The rechargeable NiCad battery in your cordless phone may need to be replaced if the handset will not function when the TALK button is pressed after recharging for 12 hours.

1To remove the battery door, press and slide downward.

2Carefully disconnect the battery pack and dispose of it properly. See Battery Disposal below.

3To replace, observe connection orientation and connect the new battery and replace the door. Return the handset to the base and charge the battery overnight (at least 12 hours).

Handset Battery Disposal

The rechargeable nickel cadmium (NiCad) battery in this product must be recycled or disposed of properly in compliance with all applicable laws. It may not be thrown in the trash. Certain states or municipalities require recycling and have established collection pro- grams. Please contact your local waste removal authority for instructions, or return to Cobra for recycling. Wrap batteries carefully and mail postage prepaid to: Cobra Electronics Corpor- ation,6500 W. Cortland Street, Chicago, Illinois 60707, Attn: Battery Recycling.

Or contact the Rechargeable Battery Recycling Corporation (RBRC) at 1-800-8BATTERY for a local recycling center near you. For more informa- tion about battery recycling, the RBRC has a web site at: http://www.RBRC.com

DO NOT PUT BATTERIES INTO FIRE OR EXPOSE TO HIGH HEAT. THEY MAY EXPLODE.

Handset Battery

Disposal

	38		39

Image 22

Contents If You Think You Need Service FCC Information Included AccessoriesWhat’s Included with Your CP-9135 Customer Support Controls and Indicators Our Thanks to You22 23 How to Use Your Cobra CP-9135 900 MHz Cordless Telephone Operating Your CP-9135Important Safety Instructions Installation Quick Set-Up GuideQuick Set Up Guide Quick Set-Up GuideWall Mounting Instructions Wall MountingInstructions Plug 6phone cord into Line 1-2 jack on rear of baseReal Time Line Status/Base & Handset OperationReal Time Line Status Base & Handset Line 1 or Line 2 will flash if there is a line on hold, orAnswering Calls From The Handset Answering Calls From The HandsetPick up handset Line button Answering Calls From The BaseAnswering Calls From The Base ButtonPlacing Calls From The Handset Placing Calls From HandsetPlacing Calls Placing Calls From The BaseSelection ChannelFlash Secur-LocMute ControlHearing Aid Compatibility Last Number Instant Redial Last Number Delayed RedialLast Number Delayed Redial Last Number Instant RedialMemory Number Storage Memory NumberStorage Push and release button onceMemory Number Dialing Memory Number DialingTo Find To Find The HandsetIntercom Mode From The Handset Intercom Mode From HandsetIntercom Mode Intercom Mode From The BaseHold Button On The Handset and Base Person using the handset should pushHold Button On Handset Base Handset BaseConference Calling Using Both Lines Conference Calling From Handset BaseRinger Switches Ringer SwitchesHandset Battery Recharging Handset Battery RechargingPrivate Call Battery Saver Voice ScramblingPrivate Call Voice Scrambling Battery Saver Private Call prevents other cordless phones orReplacing Handset Batteries Handset Battery DisposalHandset Battery Disposal Replacing Handset BatteriesHeadset Operation CleaningSprOperationadLeft Spread RightOperationPage ChargingContactsPhone is dead Are power adapter and phone cord connected? Troubleshooting Frequently Asked QuestionsHandset seemsdead Other cordless phones Fluorescent fixtures Frequently Asked Questions Limited One Year Warranty Accessory Order Form Accessories