Preparing and using the remote control
■Loading a Lithium battery into the remote control
1Push and slide the battery compartment lid.
1
2
2Install a Lithium battery.
Be sure to align the polarity of the battery properly.
3Position the lid over the compartment and snap it back into place.
■Operating the remote
control
Point the remote control toward the projector’s infrared remote sensor, and press a button on the remote control.
• Operating the projector from the front
3m | 15 | 15 |
| ||
|
| |
5m |
|
|
• Operating the projector from the rear
15 |
15 |
5m |
3m |
Lithium battery
•Before using the battery, be sure to observe the Safety Precautions described in previous pages.
•Remove the battery from remote control when not using for extended periods.
The remote control
•The remote control may fail to operate if the infrared remote sensor is exposed to bright sunlight or fluorescent lighting.
•Do not drop or bang.
•Do not leave in hot or humid locations.
•Do not get wet or place on top of wet objects.
•Do not take apart.
•In rare cases, ambient conditions could impede the operation of the remote control. If this happens, point the remote control at the main unit again, and repeat the operation.
18
