Turning the power off | Toshiba TDP-S9 specification

Note

• The start-up screen will disappear after a moment.

■Turning the power off

1 Press the I/ ON/STANDBY button.

A message appears on the screen, confirming that you wish to shut off the power. This message will disappear after a moment. (This operation is no longer valid after the message disappears.)

2 Press the I/ ON/STANDBY button again.

The screen turns off, but the internal cooling fan continues to operate for a short while. Then, the projector goes into standby mode.

When cooling lamp

During internal cooling

After cooling complete

(Green)
Flashing	(Green)

A

(Green)

B

(Green) Flashing

C

ADuring cooling, the LAMP indicator flashes. In this state, the power cannot be turned back on.

BAfter the LAMP indicator goes off, the cooling fan continues to operate for a short while, in order to expel excess internal heat. If you are in a hurry, there is no problem with unplugging the power cord or turning off the main power switch in this state.

CIn standby mode

Note

•The projector consumes about 6W of power in standby. We recommend that you unplug the power cord or turn off the main power switch if you will not be using the projector for an extended period.

PRECAUTION

•If the power cord is unplugged before cooling is complete, give the lamp time (about 5 minutes) to cool before plugging it back in. If the lamp overheats, it may fail to light, and its lifetime will be shortened.

22

Image 22

Toshiba TDP-S9 owner manual Turning the power off, Press the I/ ON/STANDBY button again

Contents

TDP-S9 Svga Safety Precautions USA only Before Using Important Safety Instructions Source of Light Heat Important Safety Instructions Lightning storms Accessories Replacement Parts Place and Manner of Installation Power Supply Cord SelectionImportant Precautions Save Original Packing Materials Important Precautions Avoid Volatile Liquid Exemption Clauses Remote Control Battery Other Cautions and Informations Contents Maintenance Others Checking the package contents Names of each part on the main unit Preparations Names of each part on the control panel and remote control Parts on the rear panel Loading a Lithium battery into the remote control Preparing and using the remote controlOperating the remote Control Placement Styles PlacementProjection Distance and Size Connection Before connection Turning the power on Turning the power on and offConnecting the power cord Removing the lens cover Turning the power off Press the I/ ON/STANDBY button again Select the language Turn on the powerBasic operations Activate the connected device Adjusting the screen size and focus Projector placement angle adjustmentsTo adjust the horizontal angle, use the tilt adjuster Manually selects an input source Source Using handy featuresCorrecting the keystone distortion Keystone Press the remote controls Mute button Automatically adjusts frequency and phase AutoSwitching the image aspect ratio 43/169 Cutting off the sound temporarily Mute Using the menus How to use the menus Using the menu Image menu Tint Video menuSaturation Sharpness Tracking PhaseDisplay menu Position Language menu Language Using the menu Advanced menu Audio menu VolumeMute When the lamp is broken Lamp replacementImmediately replace the lamp when Lamp LED lights amber About lamp Remove the lamp cover Unplug power cord Wait until lamp is sufficiently cooledLamp Hours Reset Pull out the lamp Lens cleaning Lens and main unit cleaningLamp replacement Main unit cleaning Status display Brightness Before calling service personnel List of general specifications SpecificationsSpecification List of supported signals RGB signals List of supported signals Video, S-Video signals SpecificationsList of supported signals Hdtv signals Pin assignment of Computer in terminals Pin assignment of S-Video terminal Separately Sold Product