Wall Mounting Instructions

The following steps enable installation on a new or existing telephone wall- mounting plate or directly onto a wall. (Your Cobra Intenna is designed to be used with any AT & T, GTE, local phone company or other wall-mounting plates that can be purchased from most local electronics stores.)

¥Run telephone cord through cord wrap channel on bottom of base. (As shown).

¥Plug modular phone connector into telephone wall jack.

¥Align mounting studs on the plate to the holes on the bottom of the Intenna base; push base onto studs and slide down on the wall plate.

Modular Phone Jack

Diagram #2: In-

stallation on a telephone wall- mounting plate

Mounting Studs

¥Attach the power adapter to the POWER connection (on the base of the phone) and plug into a household AC power outlet.

¥To install directly on any wall, youÕll need to provide two screws and wall anchors; follow these steps:

ÑDrill two holes 3 1Ú4" apart and insert the wall anchors.

ÑDrive the screws into the anchors until the head of each screw is protruding about 1/8" from the wall.

ÑAlign the holes in the cordless base over the screw heads; push base in and slide down on screws (see diagram #3).

ÑPlug modular phone connector into telephone wall jack; attach the power adapter to the POWER connection (on the base of the phone) and plug into to a household AC power outlet.

Screw Heads

Diagram #3: Installation directly on a wall

Modular Phone Jack