Battery Installation

To install the 3.6V 400mAh cordless handset battery pack:

1.	Slide open the battery compartment door on the back of
	the handset.
2.	Insert the battery into the battery compartment and then
	plug the battery connector into the 2-pin connector
	located just inside the battery compartment.
3.	Close the battery compartment door and place the
	handset on the base unit cradle.

HEADSET AND DATA JACK

The Data Jack

The jack located on the side of the telephone labeled "DATA" is a convenience jack. It is useful for connecting a fax machine or modem when there is no telephone jack available for that device.

4. Once you have installed the battery pack and placed the

handset on the base you will hear a tone indicating the

handset has connected with the base and will

successfully charge.

Data Jack

The Headset Jack

The headset jack is located on the side of the

2.4	GHz

In Use

Low Batt.

5. IMPORTANT: Charge the battery pack for at least 12

hours before using the handset the first time.

6. The CHARGE LED on the base illuminates when the handset is making contact with the charge terminals.

handset and is a standard 2.5mm plug. Simply plug the headset (not included) into the jack and the headset will be active.

Note: When the headset is plugged into the

GHI

Talk

JKL

Flash

ABC

Redial

3 DEF

MNO

Battery Duration

A fully charged battery lasts for approximately:

telephone, the microphone and earpiece on the handset are not active.

7PQRS	8 TUV
	8 TUV	9WXYZ
		9WXYZ

• 5 hours when you use the handset continuously (talk time).

•7 days when the handset is not in use (standby).

When the Battery Needs Charging

•The handset will beep.

•The In Use/Low Batt. LED will flash slowly.

When to Purchase a New Battery Pack

If the battery lasts only a few minutes even after a full charge, the usable life of the battery has expired and needs to be replaced. For replacement batteries visit http://www.bell-equipment.com/support or

you can contact Aastra Telecom customer support center

at 1-888-663-1505 for information about how to order a new battery.

Belt-clip

Headset Jack

Belt-Clip

Be sure to remove the belt-clip filler cap prior to installing the belt-clip. Install the belt-clip as shown.

To remove the belt-clip, squeeze the release at the top of the clip where it attaches to the phone, and gently pull the clip up and out of the handset.