Cordless Telephone Operation
Receiving Calls when the handset is in the base unit
1)When the phone rings, lift the handset. The base unit’s IN USE LED indicator will light up. [NOTE: The handset’s RINGER SWITCH must be in the “ON” position
for the Ringer to operate.]
2)Start your conversation.
3)To amplify
4)Slide the Tone Control switch up or down to attain optimum word clarity.
5)To end your conversation, either press the TALK button or replace the handset on the base unit. When you place the handset on the base unit charge cradle, you activate the automatic STANDBY feature.
Receiving Calls when the handset is NOT IN the Base Unit
1)When the phone rings, press the TALK button, The IN USE LED indicator on the handset will light up.
2)Remember that the handset’s Ringer must be set to ON for the handset to ring when receiving incoming calls.
3)Start your conversation.
4)To amplify
5)Slide the Tone Control switch up or down to attain optimum word clarity.
6)To end you conversation, either press the TALK button or place the handset back in the base unit. When you place the handset in the base unit’s change cradle, you automatically activate the STANDBY feature.
NOTE: If you are far away from the base unit, the handset will emit a beeping sound to warn you that the background noise level is too high for proper communication between the handset and the base unit. When you hear this sound, you should move closer to the base unit to reduce the noise level interference. Otherwise, the call
will automatically cut off.
Automatic Amplifier Setting
To set the Amplifier so that it AUTOMATICALLY returns to your previous volume setting every time you use the handset:
1)Press the MEMO button twice.
2)Press the (*) button.
3)To turn this feature OFF, repeat above steps.
13
13 |