Marquis MW10, EUROMW5 manual Handset Retaining Hook, Installation for Wall Mounting

Page 11

WALL MOUNTING

1.HANDSET RETAINING HOOK

Aremovable clip to hold the handset secure when in the wall mounted position is located below the hook switch.

Remove the clip hook, turn it 180 degrees round and slot it back into place (figure 5).

MOUNTING

WEDGE

1.PRESS THE RELEASE TABS .

2.SNAP INTO PLACE.

FIGURE 6

1. UNSNAP

2. ROTATE 180 .

3. SNAP INTO PLACE.

FIGURE 5

2. INSTALLATION FOR WALL MOUNTING

Plug one end of the line cord into the line jack on the top of the base unit.

Plug the other end of the line cord into the wall jack receptacle.

Guide the phone onto the studs on the wall jack.

Pull down firmly until you feel it snap into place.

The unit is now wall mounted (figure 6).

11

Image 11

Contents Deluxe Single Line Telephone EUROMW5 or MW10DOC Notice and Load Number Statement Safety and ComplianceFCC Part 15 Compliance If Unit is Equipped with Power Adapter Important Safety InstructionsNotification to Telephone Company Contents Features Controls Definition of Controls To Prepare the EUROMW10 Telephone for USE InstallationContents Handset Retaining Hook Installation for Wall MountingWall Mounting Message Waiting Switches Message Waiting FeatureMessage Waiting Message Waiting ProgrammingProgramming TouchLite tm TouchLiteTM Feature ProgrammingReceiving a Call Placing a Call Using the HandsetOperation Programming a Flash Timing Delay into Speed Dial Memory To change the flash to option 2, the 600ms flash timing Flash Options Standard ProgrammingProgramming a Pause into Memory Ringer Volume Control Handset Volume ControlUsing the Data Port Care and Maintenance Service Information Statement of Limited Warranty Statement of Limited Warranty