Marquis MW10, EUROMW5 manual Flash Options Standard Programming

Page 17

OPERATION

FLASH OPTIONS (STANDARD PROGRAMMING)

The EURO Series is pre-programmed with two standard flash options:

1.Option 1 is the programmable 100ms flash timing

2.Option 2 is the standard default of 600ms flash timing.

To change the flash to option 2, the 600ms flash timing:

1.Lift the handset.

2.Press the 'store' button to enter the programming mode.

3.Press digit 2 using the numeric dial pad.

4.Press digit 1 using the numeric dial pad.

5.Press the STORE button to store the new setting and to exit programming mode. A short beep should be heard to indicate a valid entry .

6.Hang up the handset.

Note: if a double beep is heard at any time during the programming, an invalid entry has been entered and the whole process must be started all over again.

To change the flash back to option 1, the 100ms flash timing:

1.Lift the handset.

2.Press the 'store' button to enter the programming mode.

3.Press digit 2 using the numeric dial pad.

4.Press digit 0 using the numeric dial pad.

5.Press the 'store' button to store the new setting and to exit programming mode. A short beep should be heard to indicate a valid entry .

6.Hang up the handset.

Note: if a double beep is heard at any time during the programming, an invalid entry has been entered and the whole process must be started all over again.

17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Deluxe Single Line Telephone EUROMW5 or MW10DOC Notice and Load Number Statement Safety and ComplianceFCC Part 15 Compliance If Unit is Equipped with Power Adapter Important Safety InstructionsNotification to Telephone Company Contents Features Controls Definition of Controls To Prepare the EUROMW10 Telephone for USE InstallationContents Handset Retaining Hook Installation for Wall MountingWall Mounting Message Waiting Switches Message Waiting FeatureMessage Waiting Message Waiting ProgrammingProgramming TouchLite tm TouchLiteTM Feature ProgrammingReceiving a Call Placing a Call Using the HandsetOperation Programming a Flash Timing Delay into Speed Dial Memory To change the flash to option 2, the 600ms flash timing Flash Options Standard ProgrammingProgramming a Pause into Memory Ringer Volume Control Handset Volume ControlUsing the Data Port Care and Maintenance Service Information Statement of Limited Warranty Statement of Limited Warranty
Top Page Image Contents