MK1996.OM.QXD 5/19/03 12:03 PM Page 10
OPERATION (CONTINUED)
SETTING THE CALL TONES
This unit will provide three user selectable call ringer signals to alert you of an incoming signal. Set the call tone as follows:
1 |
2 |
|
3 |
|
2 | 1 |
|
Press the FUNC button seven times; “C” will appear and the call tone number will blink.
SCANNING CHANNELS
Within eight seconds, press the CHANNEL/VOLUME Up ❶ or Down
❷button to set the call tone (1 to 3); the selected call tone will sound. Press the PTT button ❸ or wait eight seconds to confirm and exit.
This feature will allow you to monitor all channels automatically for valid signals. While scanning, you can transmit and receive. When a signal is received, scan is interrupted and you will hear the channel for five seconds. After five seconds, the unit will resume scanning unless the SCAN button is pressed again as follows:
1 |
To start Scan mode, press and release the SCAN button; “SCAN” will appear in the display and the unit will scan through the 22 main channels. When an active channel is found, it will be heard for five seconds, and then scanning will resume.
2 | 1 |
| |
| 2 |
To exit the Scan mode, press the SCAN ❶ or FUNC ❷ button; “SCAN” will disappear from the display.
10