MK1996.OM.QXD 5/19/03 12:03 PM Page 8
OPERATION (CONTINUED)
SETTING THE TRANSMIT POWER
Set the transmit power to Hi (1.8W TX power) or Low (500mW TX power) as follows:
1 |
Press the FUNC button three times; “P” will appear and “H” or “L” will blink.
2 |
|
3 |
|
2 | 1 |
|
Within eight seconds, press the CHANNEL/VOLUME Up ❶ or Down
❷button to select H” (High) or “L” (Low). Press the PTT button ❸ or wait eight seconds to confirm and exit.
NOTE: If the battery is low, the TX power will be automatically switched to LO.
On FRS frequencies
SETTING THE DW (DUAL WATCH)
This feature allows you to monitor two channels at the same time. While in the Dual Watch mode, the unit will continuously monitor both the primary and dual watch channel. Received signals will be heard for five seconds, then the unit will resume scanning the two channels. Pressing the PTT button during a received transmission will set the unit to transmit on the same channel. Pressing the PTT button when no signal is received will set the unit to transmit on the primary channel. Set as follows:
1 |
2 |
|
3 |
|
2 | 1 |
|
Press the FUNC button four times; “DW” will appear and “d” and “oF” or a number will blink.
Within eight seconds, press the CHANNEL/VOLUME Up ❶ or Down
❷button to select the desired channel. (Select “d” and “oF” for cancelling or turning off the Dual Watch function.) Press the PTT button ❸ or wait eight seconds to confirm and exit.
TO CANCEL THE DUAL WATCH
To cancel, simply press the SCAN or FUNC button.
8