1.1Installing and charging the cordless handset battery pack
1.Slide off the battery compartment cover to remove it.
2.Place the supplied rechargeable battery pack in the battery compartment, with the battery connector plugged in, as shown.
3.Slide the battery compartment cover back on.
4.Put the handset on the charger to charge for at
least 24 hours. Once charged, the 
will indicate that the handset is fully charged.
5.Use only the rechargeable battery pack provided.
1.2Assembling the rubber band of cordless handset (Not applicable
for L70xCM models)
If you have purchased additional rubber band(s) of the cordless handset separately, refer to the following steps for replacement. To remove the originally installed rubber band, dig out the rubber band from handset bottom gap and then take it off from handset around.
1.To assemble the rubber band, align the protuberant pins of the rubber band with the holes around of the handset sides and click the rubber band into place. Respect the direction, side with gap should be attached to the handset bottom, as shown.
Getting Started | 7 |
|
|