SOYO G668 Ethernet IP Phone User Guide
nat addr: The NAT IP address required by certain type of traversal method.
phone number: Virtual IP phone number, the caller ID that will show up on the recipient’s IP phone.
account: H.323 ID of the IP phone.
rtp port: RTP port is the port transferring and receiving voice flow using UDP. Please fill an even number between 1024 and 65535 into this field.
register port: Register port is the source port used by the IP phone to register to the gatekeeper. Please enter a number from 1024 through 65535 into this field.
signal port: Signal port is Q.931 port using TCP. It is arranged from
control port: This port is H.245 port using TCP. Please enter a number from 1024 through 65535.
Note: All above ports are the source ports that IP phone use to communicate with gatekeeper server. Please make sure the network firewall does not block them.
Note: If there are many IP phones traversing in the NAT at the same time, each IP phone should be assigned with different port numbers.
Phone Settings
Note: Please check with your VoIP service provider for the phone settings. Changing the settings without proper guidance may result the IP phone not functioning.
ring type: The ring tone the caller will hear when he calls this IP phone.
forward number: Enter the phone number that will receive forwarded calls into this field.
fwd always: Forward all calls by checking this box.
fwd noanswer: Forward calls without answering by checking this box.
fwd poweroff: Forward calls if power off by checking this box.
fwd busy: Forward calls if busy by checking this box.
answer: Enter a number from 0 through 60 to set the entries of the seconds before the phone forward the calls.
16