SOYO G668 manual Installation within a Home or Office Network

Page 11

SOYO G668 Ethernet IP Phone User Guide

Installation within a Home or Office Network

Broadband

Modem

WAN LAN

Router

 

 

Computer 1

 

 

Computer 2

 

 

Computer

WAN

LAN

(Optional)

 

IP Phone

1.Connect one end of the Ethernet RJ-45 cable to an open Ethernet LAN port on your router, and connect the other end of the cable to the WAN port at the rear of the G668 IP phone.

2.Using another RJ-45 cable, you can connect one end of the Ethernet RJ-45 cable to your computer, and connect the other end to the LAN port at the rear of the G668 IP phone. (This is an optional step. IP phone can work without the computer)

3.Connect the power adapter to the AC outlet and the power jack at the rear of G668 IP phone.

4.Once the IP Phone is powered up, the booting sequence will begin. You will see the following information displayed on the LCD screen:

Booting …

È

DHCP

Connecting …

È

Ready For Calls

SOYO_Group

9

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Page Safety Information Introduction Table of ContentIntroduction Safety InformationConfiguration with a Single Computer Configuration within a Home or Office Network Package Contents Front Panel of Soyo G668 IP phone Keys Rear Side of Soyo G668 IP phone Installation with a Single Computer InstallationDhcp Installation within a Home or Office Network Soyo G668 Ethernet IP Phone User Guide Entering Configuration Mode Configuration via IP Phone KeypadConfiguration for Dhcp default Configuration for Static IP Configuration for PPPoEPress Speaker Network Settings Configuration via Web BrowserProtocol Settings Phone Settings Address Book Other SettingsSave/Reboot Soyo G668 Ethernet IP Phone User Guide Software Upgrading Issue Solution TroubleshootingPhone@soyousa.com Appendix Port Forwarding
Top Page Image Contents