Spirit Communications System ConnecT/R owner manual Installation Instructions

Page 8

4

Installation

A complete ConnecT/R has the components shown in Figures 3 and 4. You could have two telephone devices attached and you do not have to have a SPIRIT Telephone attached.

INSTALLATION INSTRUCTIONS

1.Never install telephone wiring during a lightning storm.

2.Never install telephone jacks in wet loca-

tions unless the jack is specifically designed for wet locations.

3.Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.

4.Use caution when installing or modifying telephone lines.

AC

Telephone Device: Fax, Modem, Answer/Record

Power

Outlet

Machine, Telephone, etc.

Controller

ConnecT/R

STATION

JACK

4-Wire Cords

SPIRIT Telephone

Directly connected by a cord from one unit to the other, or connected via a wiring run.

Figure 3. SPIRIT ConnecT/R with Attached SPIRIT Telephone and Telephone Device

Image 8
Contents Spirit Table of Contents Important Safety Instructions Input rating Introduction Spirit ConnecT/RPage ConnecT/R Installation Installation InstructionsSpirit ConnecT/R without Attached Spirit Telephone Telephone Device Business Requirement ModePage Page Mount the ConnecT/R optional Page Station Jack Input rating Test the equipment Using the Telephone Device Answering CallsPaging Interactions with Spirit System Features Features Interactions LimitationsHfai Lifting Troubleshooting Operational Difficulty What to Check RingingOperational Difficulty What to Check Hold MiscellaneousOperational Difficulty What to Check Cordless Telephone Operational Difficulty What to Check Answer/record MachineCredit Card Readers Facsimile MachineGeneral Operational Difficulty What to Check Modem Appendix a Wiring Requirements Page Index FCC Warning Statement