Spirit Communications System ConnecT/R owner manual Input rating

12

ConnecT/R. You can connect it by plugging it into the TEL DEVICE jack on the ConnecT/R or by plugging it into the wall jack that is connected to the TEL DEVICE jack on the ConnecT/R.

To install two telephone devices on a ConnecT/R, use a T-type adapter (AT&T part # 267A2 or 267A). Plug the adapter into the TEL DEVICE jack (either directly or indirectly through a wall jack, as described above) and plug the telephone devices into the adapter jack.

5.Connect the ConnecT/R to the AC power outlet. Plug the power connector into the POWER jack on the back of the ConnecT/R. To prevent the power cord from pulling out easily, make a small loop of cord near the power connector and slip it behind the strain relief tab next to the POWER jack on the ConnecT/R. Plug the wall transformer into an AC power outlet that is at least 3 feet away from the controller and not controlled by a wall switch. (If it is any closer to the controller, you may hear a hum on your SPIRIT System.)

NOTE: Use only a UL Listed wall plug-in power transformer that has Class 2 outputs and the following characteristics:

Input rating:	99-127 V AC rms 60 Hz
	150 mA maximum
Output rating:	27-35 V DC at 200 mA
	14-18 V DC at 200 mA

The power transformer supplied with the ConnecT/R has these characteristics.

AC

Power Outlet

ConnecT/R